- Full Version
     
     

Condensed Specs.
Part 1 General

1.01 Section Includes
A. Motorized rollershade system for reduction of heat gain, glare control and aesthetic appeal.

1.02 System Description
A. Motor operated rollershades with hardware.

1.03 Submittals
A. Product data: Submit five copies of manufacturers technical data and installations instructions.
B. Samples: Submit three samples of each shade cloth with complete color swatch.
C. Shop Drawings: Submit drawings of mechanical products with appropriate dimensions.

1.04 Quality Assurance
A. The manufacturer of these products shall show a minimum of 20 years documented experience.
B. The installer shall show a minimum of 3 years experience with these systems.

Part 2 Products

2.01 Manufacturers
A. SOS™ “Sun Or Shade”, a division of Inside Outfitters, Inc.
5725 Avery Rd., Dublin, Ohio 43016
Ph: 800.742.3372, Fx: 877.880.3496, E: info@sos-shades.com

2.02 Materials
A. Shade Fabrics: Flame Retardant (DIN 4102 B1, NFPA 701, Dept. of Transportation Motor Vehicle Safety Standard MVSS 302 and California Administrative Code Title 19), 100% Trevira with openness factor (o.f.) properties between 0%, ½%, 5%, 25%. All fabrics are metallisized with aluminum adhesion per ISO 2409 to classification 0, color fastness per ISO 105-BO2 to greater than 5 for color, formaldehyde and PVC free, and inherently anti-static/repellant to dust.
1. Verosol

B. Tube: Shade Fabric shall be mounted on to 1” diameter aluminum tube. Custom sized stubs available when dictated by size of shade composition.

C. Motor Control Systems: All systems utilize a Somfy motor or group of motors, “world’s largest manufacturer of tubular motors”. All motors are thermally protected, totally enclosed and maintenance free. (SOMFY UL approved motors can be found in the following file numbers: E60495, E60888, E63714) Each Motor is selected appropriately to operate each shade based on size and weight. All systems utilize low voltage controls.
§ Electrical requirements: 24VDC, one phase 60 hertz. .35 Amp
Motor Control Options:
1. IGC-DC System
2. GC-DC System

D. Fascia Cassette: All fascia systems shall be prime painted with baked enamel utilizing the powder paint method to ensure an environmental friendly application. Wet paint method shall not be accepted.

E. Shade Mounting Brackets: Shall be manufactured from steel, universal for inside and outside mounting. Brackets shall snap easily onto cassette system once fastened to opening.

F. Hembar: Shall be a continuous aluminum bar 3/4” X 1/8” with sufficient weight to allow the shade to close without buckling or sagging. )

G. Side (Sill) Channels (Option): Dual extruded .062” aluminum channel through which each side of each shade travels to create blackout application. The rails shall contain soft brushes on a minimum of one side depending on application to enclose the fabric shade in a light tight condition. The side and bottom channels should be installed in a light bead of caulking to prevent light penetration.