 -
Full Version
Condensed Specs.
Part 1 General
1.01 Section Includes
A. Motorized shades and hardware.
1.02 System Description
A. Motor operated roman style shades via low voltage controls.
1.03 Submittals
A. Product data: Submit five copies of manufacturers technical
data and installations instructions.
B. Samples: Submit three samples of each shade cloth with
complete color swatch.
C. Shop Drawings: Submit drawings of mechanical products with
appropriate dimensions.
1.04 Quality Assurance
A. The manufacturer of these products shall show a minimum
of 20 years documented experience.
B. The installer shall show a minimum of 3 years experience
with these systems.
Part 2 Products
2.01 Manufacturers
A. SOS™ “Sun Or Shade”, a division of Inside
Outfitters, Inc.
5725 Avery Rd., Dublin, Ohio 43016
Ph: 800.742.3372, Fx: 877.880.3496, E: info@sos-shades.com
2.02 Materials
A. Shade Fabrics Translucent Type:
Translucent fabrics with openness factors of 1-25%. The fabric
color shall be selected from standard color line unless SWSPECIALS
is selected. SWSPECIALS allows specifier to create custom
color (minimum quantities required). The fabric is to be color
fast and shall not be affected by moisture or heat.
1. Phifer
2. 3G Mermet
3. Hexcel
4. Verosol
B. Shade Fabrics Opaque/Room Darkening Type:
The fabric shall have a high degree of opacity for effective
control of light. The fabric must have sufficient rigidity
to insure straight hanging, resist curl, twist, bowing and
distortion. It must be dimensionally stable and will not shrink
or stretch. The color shall be selected from standard colors.
All seams are to be heat-sealed. Sewing is not accepted.
C. Fabric Construction: Shades shall be supported by transverse
aluminum rods sewn into the shade cloth at 9” o.c. horizontally.
The aluminum rods shall be supported by plastic slide carriers
attached at each end of the rod. The shades shall stack Roman
style as they retract. The shades normally stack at the top
of the structure but under special conditions or optionally,
may be specially set up to stack at the bottom of the structure.
D. Motor Control Systems: All systems utilize a Somfy motor
or group of motors, “world’s largest manufacturer
of tubular motors”. All motors are thermally protected,
totally enclosed and maintenance free. (SOMFY UL approved
motors can be found in the following file numbers: E60495,
E60888, E63714) Each Motor is selected appropriately to operate
each shade based on size and weight. All systems utilize low
voltage controls.
Electrical requirements: 120V, one phase 60 hertz. Amp .7-1.8
depending on size of shade.
1. Simmple System ™
2. Smmart System™
4. GC System “Group Control”
5. IGC System “Individual Group Control”
6. 2-4-1 System
E. Shade Mounting Brackets: Steel, 1/8” thick type
as required to suit indicated mounting and necessary torque.
Center bracket utilized as needed to suit span, shade weight
and indicated mounting.
F. Valance System (Not applicable for bottom up Roman Shade
Style)
|
