- Full Version
     
     

Condensed Specs.
Part 1 General

1.01 Scope
A. Motorized Rollershade and hardware.

1.02 System Description
A. Motor operated rollershade for horizontal or inclined sun control.

1.03 Submittals
A. Product data: Submit five copies of manufacturers technical data and installations instructions.
B. Samples: Submit three samples of each shade cloth with complete color swatch.
C. Shop Drawings: Submit drawings of mechanical products with appropriate dimensions.

1.04 Quality Assurance
A. The manufacturer of these products shall show a minimum of 5 years documented experience.
B. The installer shall show a minimum of 3 years experience with these systems.

Part 2 Products

2.01 Manufacturers
A. SOS™ “Sun Or Shade”, a division of Inside Outfitters, Inc.
5725 Avery Rd., Dublin, Ohio 43016
Ph: 800.742.3372, Fx: 877.880.3496, E: info@sos-shades.com

2.02 Materials
A. Shade Fabrics Type T:
Translucent fabrics with openness factors of 1-25%. The fabric color shall be selected from standard color line unless SWSPECIALS is selected. SWSPECIALS allows specifier to create custom color (minimum quantities required). The fabric is to be colorfast and shall not be affected by moisture or heat.
1. Phifer
2. 3G Mermet
3. Hexcel
4. Verosol: (PVC free)

B. Shade Fabrics Type BO:
The fabric shall have a high degree of opacity for effective control of light. The fabric must have sufficient rigidity to insure straight hanging, resist curl, twist, bowing and distortion. It must be dimensionally stable and will not shrink or stretch. The color shall be selected from standard colors. All seams are to be heat-sealed. Sewing is not accepted.

C. Motor Control Systems: All systems utilize a Somfy “STARHEAD” motor or group of motors, “world’s largest manufacturer of tubular motors”. Roundhead motors shall not be accepted. All motors are thermally protected, totally enclosed and maintenance free. (SOMFY UL approved motors can be found in the following file numbers: E60495, E60888, E63714.) Each Motor is selected appropriately to operate each shade based on size and weight. All systems utilize low voltage controls. Electrical requirements: 120V, one phase 60 hertz. Amp 1.6-2.6 depending on size of shade.

D. Switches: FTS Switch (Single IGC Switch)

E. Tube: extruded aluminum, 2.5” or 3.1 diameter.

F. Shade Mounting Brackets: Shall be manufactured from .060” galvanized steel, reversible for right and left hand mounting. The brackets may be field mounted inside, outside or ceiling mounted. Brackets rated 85 Nm.