- Full Version
     
     

Condensed Specs.
Part 1 General

1.01 Section Includes
A. Manual rollershade system for heat gain, glare control and aesthetic appeal.

1.02 System Description
A. Clutch operated rollershades with bead chain control.

1.03 Submittals
A. Product data: Submit five copies of manufacturers technical data and installations instructions.
B. Samples: Submit three samples of each shade cloth with complete color swatch.
C. Shop Drawings: Submit drawings of mechanical products with appropriate dimensions.

1.04 Quality Assurance
A. The manufacturer of these products shall show a minimum of 20 years documented experience.
B. The installer shall show a minimum of 3 years experience with these systems.

Part 2 Products

2.01 Manufacturers
A. SOS™ “Sun Or Shade”, a division of Inside Outfitters, Inc.
5725 Avery Rd., Dublin, Ohio 43016
Ph: 800.742.3372, Fx: 877.880.3496, E: info@sos-shades.com

2.02 Materials:
A. Shade Fabrics: Flame Retardant (DIN 4102 B1, NFPA 701, Dept. of Transportation Motor Vehicle Safety Standard MVSS 302 and California Administrative Code Title 19), 100% Trevira with openness factor (o.f.) properties between 0%, ½%, 5%, 25%. All fabrics are metallisized with aluminum adhesion per ISO 2409 to classification 0, color fastness per ISO 105-BO2 to greater than 5 for color, formaldehyde and PVC free, and inherently anti-static/repellant to dust.
1. Verosol

B. Tube: Shade Fabric shall be mounted on to 1 ¼” diameter aluminum tube.

C. Bead Chain Clutch: The clutch incorporates an adjustable slip clutch to control the rate of fall from free running zero friction factor to a factor of 100%. The shade may be adjusted to stop and hold at any position. The bead chain shall contain automatic stops to prevent the shade from over winding or unrolling off the tube. The bead chain may be either PVC or metal ball type.

D. Fascia Cassette: All fascia systems shall be prime painted with baked enamel utilizing the powder paint method to ensure an environmental friendly application. Wet paint method shall not be accepted.

E. Shade Mounting Brackets: Shall be manufactured from steel, universal for inside and outside mounting. Brackets shall snap easily onto cassette system once fastened to opening.

F. Hembar: Shall be a continuous aluminum bar 3/4” X 1/8” with sufficient weight to allow the shade to close without buckling or sagging.

G. Side (Sill) Channels (Option): Dual extruded .062” aluminum channel through which each side of each shade travels to create blackout application. The rails shall contain soft brushes on a minimum of one side depending on application to enclose the fabric shade in a light tight condition. The side and bottom channels should be installed in a light bead of caulking to prevent light penetration.