Condensed
Specs.
Part 1 General
1.01 Section Includes
A. Manual dual rollershade system for room darkening/light
control and hardware.
1.02 System Description
A. Clutch operated rollershades with bead chain
control.
B. Shade Type T is translucent. Shade Type O is
opaque.
1.03 Submittals
A. Product data: Submit five copies of manufacturers
technical data and installations instructions.
B. Samples: Submit three samples of each shade
cloth with complete color swatch.
C. Shop Drawings: Submit drawings of mechanical
products with appropriate dimensions.
1.04 Quality Assurance
A. The manufacturer of these products shall show
a minimum of 20 years documented experience.
B. The installer shall show a minimum of 3 years
experience with these systems.
Part 2 Products
2.01 Manufacturers
A. SOS™ Shade Systems, a division of
Inside Outfitters, Inc.
5725 Avery Rd., Dublin, Ohio 43016
Ph: 800.742.3372, Fx: 877.880.3496, E: info@sos-shades.com
2.02 Materials:
A. Shade Fabrics: Flame Retardant (DIN 4102 B1,
NFPA 701, Dept. of Transportation Motor Vehicle
Safety Standard MVSS 302 and California Administrative
Code Title 19), 100% Trevira with openness factor
(o.f.) properties between 0%, ½%, 5%, 25%.
All fabrics are metallisized with aluminum adhesion
per ISO 2409 to classification 0, color fastness
per ISO 105-BO2 to greater than 5 for color, formaldehyde
and PVC free, and inherently anti-static/repellant
to dust.
1.Verosol
B. Tube: Shade Fabric Type T shall be mounted
on to 32mm diameter aluminum tube and Shade Fabric
Type O shall be mounted on a 29mm aluminum tube.
C. Bead Chain Clutch: The clutch incorporates
an adjustable slip clutch to control the rate
of fall from free running zero friction factor
to a factor of 100%. The shade may be adjusted
to stop and hold at any position. The bead chain
shall contain automatic stops to prevent the shade
from over winding or unrolling off the tube. The
bead chain may be either PVC or metal ball type.
D. Fascia Cassette: All fascia systems shall
be prime painted with baked enamel utilizing the
powder paint method to ensure an environmental
friendly application. Wet paint method shall not
be accepted.
E. Shade Mounting Brackets: Shall be manufactured
from steel, universal for inside and outside mounting.
Brackets shall snap easily onto cassette system
once fastened to opening.
F. Hembar: Shall be a continuous aluminum bar
3/4” X 1/8” with sufficient weight
to allow the shade to close without buckling or
sagging.
G. Side (Sill) Channels (Option): Dual extruded
.062” aluminum channel through which each
side of each shade travels to create blackout
application. The rails shall contain soft brushes
on a minimum of one side depending on application
to enclose the fabric shade in a light tight condition.
The side and bottom channels should be installed
in a light bead of caulking to prevent light penetration.
|
